Remove Manual Tool From Toolholder %4 And Load Manual Tool %3 %2; Block %2 Tool %3 Cannot Become A Manual Tool; Block %2 Tool Not Existing - Siemens Sinamics S120 Diagnostic Manual

17216 [Channel %1: ] Remove manual tool from toolholder %4 and load manual tool %3 %2
Parameters: %1 = Channel number
%2 = Duplo no.
%3 = Tool identifier
%4 = Toolholder number (spindle number)
Definitions: Indicates that the specified manual tool must be loaded in the specified toolholder or spindle before the program is
continued and that the manual tool located there must be removed. A manual tool is a tool whose data are known to
the NCK but which is not assigned to a magazine location and is thus not fully accessible to the NCK, and usually also
to the machine, for an automatic tool change.
Reaction: Alarm display.
Remedy: Make sure that the manual tools are exchanged. The alarm is cleared automatically after PLC acknowledgement of
the tool change on command. Manual tools can only be used efficiently if this is supported by the PLC program.
Program Alarm display showing cause of alarm disappears. No further operator action necessary.
Continuation:
17218 [Channel %1: ] Block %2 Tool %3 cannot become a manual tool
Parameters: %1 = Channel number
%2 = Block number, label
%3 = Tool identifier
Definitions: The specified tool has a dedicated location and/or a location has been reserved for this tool in an actual magazine.
Therefore, it cannot become a manual tool.
Reaction: Correction block is reorganized.
Interface signals are set.
Alarm display.
Remedy: - Correct the NC program
- Use the programming of "DELRMRES" to check that there is no reference to an actual magazine location
Program Clear alarm with NC START or RESET key and continue the program.
Continuation:
17220 [Channel %1: ] Block %2 tool not existing
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: -
The tool which does not exist can also be a multitool (the multitool is treated like a tool).
Reaction: Correction block is reorganized.
Interface signals are set.
Alarm display.
Remedy: Correct the NC program.
Program Clear alarm with NC START or RESET key and continue the program.
Continuation:
Alarms
Diagnostics Manual, 07/2010, 6FC5398-8BP40-0BA0
NCK alarms
279