Block %2 Spline For Orientation Not Possible; Illegal Reference System For Cartesian Manual Traverse; Block %2 Illegal Tool Carrier Number Programmed Or Declared (Md); Block %2 Illegal Tool Carrier Rotation - Siemens Sinamics S120 Diagnostic Manual

14147 [Channel %1: ] Block %2 spline for orientation not possible.
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: If an orientation has been programmed while BSPLINE is active, the interpolation of
tool orientation must be interpolated via a 2nd space curve. This means that G code ORICURVE
must be active for the interpolation of the orientation.
Reaction: Correction block is reorganized.
Interpreter stop
Interface signals are set.
Alarm display.
Remedy: Change the NC program.
Program Clear alarm with NC START or RESET key and continue the program.
Continuation:
14148 [Channel %1: ] Illegal reference system for Cartesian manual traverse
Parameters: %1 = Channel number
Definitions: In the SD42650 $SC_CART_JOG_MODE, an illegal value has been entered for the reference system with Cartesian
manual travel.
Reaction: Alarm display.
Remedy: Enter a permitted value in the SD42650 $SC_CART_JOG_MODE.
Program Clear alarm with the RESET key. Restart part program
Continuation:
14150 [Channel %1: ] Block %2 illegal tool carrier number programmed or declared (MD)
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: A toolholder number was programmed which is negative or greater than the MD18088
$MN_MM_NUM_TOOL_CARRIER.
Reaction: Correction block is reorganized.
Interface signals are set.
Alarm display.
Remedy: Please inform the authorized personnel/service department. Program valid toolholder number or adapt MD 18088
$MN_MM_NUM_TOOL_CARRIER.
Program Clear alarm with NC START or RESET key and continue the program.
Continuation:
14151 [Channel %1: ] Block %2 illegal tool carrier rotation
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: A toolholder was activated with an angle of rotation unequal to zero, although the associated axis is not defined. A
rotary axis is not defined when all three direction components are zero.
Reaction: Correction block is reorganized.
Interface signals are set.
Alarm display.
Remedy: Set angle of rotation to zero, or define the associated rotary axis.
Program Clear alarm with NC START or RESET key and continue the program.
Continuation:
Alarms
Diagnostics Manual, 07/2010, 6FC5398-8BP40-0BA0
NCK alarms
167