Block %2: First Drilling Depth Incorrectly Defined; Block %2: Illegal Values For Radius And Insertion Depth Parameters; Block %2: %]Milling Direction Parameter Incorrectly Defined; Block %2: Finishing Allowance At Bottom - Depth Infeed - Siemens Sinamics S120 Diagnostic Manual
Hide thumbs
Also See for Sinamics S120:
- Function manual (1094 pages) ,
- Manual (848 pages) ,
- Equipment manual (570 pages)
Table of Contents
Advertisement
NCK alarms
61107
[Channel %1: ] Block %2: First drilling depth incorrectly defined
Parameters:
%1 = Channel number
%2 = Block number, label
Definitions:
First drilling depth is in the opposite direction to the total drilling depth. Alarm triggered by following cycle: CYCLE83.
Reaction:
Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy:
Modify drilling depth.
Program
Clear alarm with the RESET key. Restart part program
Continuation:
61108
[Channel %1: ] Block %2: Illegal values for radius and insertion depth parameters
Parameters:
%1 = Channel number
%2 = Block number, label
Definitions:
The radius (_RAD1) and insertion depth (_DP1) parameters for defining the helix path for the depth infeed have been
incorrectly specified. Alarm triggered by following cycles: POCKET3, POCKET4.
Reaction:
Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy:
Modify parameter.
Program
Clear alarm with the RESET key. Restart part program
Continuation:
61109
%[[Channel %1: ] Block %2: %]Milling direction parameter incorrectly defined
Parameters:
%1 = Channel number
%2 = Block number, label
Definitions:
The value of the parameter for the cutting direction _CDIR has been incorrectly defined. Alarm triggered by following
cycles: CYCLE63, CYCLE64, POCKET3, POCKET4.
Remedy:
- Change milling direction.
- During pocket machining (CYCLE63), the selected milling direction must match the milling direction of centering/
rough drilling.
Program
Clear alarm with the RESET key. Restart part program
Continuation:
61110
[Channel %1: ] Block %2: Finishing allowance at bottom > depth infeed
Parameters:
%1 = Channel number
%2 = Block number, label
Definitions:
The finishing allowance at the base has been specified greater than the maximum depth infeed. Alarm triggered by
following cycles: POCKET3, POCKET4.
Reaction:
Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy:
Either reduce finishing allowance or increase depth infeed.
Program
Clear alarm with the RESET key. Restart part program
Continuation:
386
Diagnostics Manual, 07/2010, 6FC5398-8BP40-0BA0
Alarms
Hide quick links:
Advertisement
Table of Contents
