Tool Move Impossible Empty Location For Tool%2 On Mag %4 Not Available; [Channel %1:] Tool Move Not Possible. Magazine No. %2 Not Available; Tool Move Not Possible. Location %2 On Magazine %3 Not Available - Siemens Sinamics S120 Diagnostic Manual

6421 [Channel %1: ] Tool move not possible. Empty location for tool %2 on magazine %4 not
available.
Parameters: %1 = Channel ID
%2 = String (identifier)
%3 = -Not used-
%4 = Magazine number
Definitions: The desired tool motion command - triggered from the MMC or PLC - is not possible. The tool cannot be moved into
the specified tool magazine. There is no appropriate location for this tool.
Reaction: NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy: - Check whether the magazine data have been defined correctly (e.g. the magazine must not be disabled).
- Check whether the tool data are correctly defined (for example, the tool location type must match the location types
allowed in the magazine).
- Check whether the magazine has simply no more room to accept another tool thanks to operating procedures.
- Check whether a location type hierarchy is defined and whether, for example, it does not allow insertion of a type 'A'
tool in a free location with type 'B'.
Program Clear alarm with the Delete key or NC START.
Continuation:
6422 [Channel %1: ] Tool move not possible. Magazine no. %2 not available.
Parameters: %1 = Channel ID
%2 = Magazine number
Definitions: The desired tool motion command - triggered from the MMC or PLC - is not possible. The magazine with the specified
number is not available.
Reaction: NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy: - Check whether the magazine data have been defined correctly.
- If the PLC issued the command for motion: check whether the PLC program is correct.
- If the MMC issued the command for motion: check whether the MMC command was assigned correct parameters.
Program Clear alarm with the Delete key or NC START.
Continuation:
6423 [Channel %1: ] Tool move not possible. Location %2 on magazine %3 not available.
Parameters: %1 = Channel ID
%2 = Magazine location number
%3 = Magazine number
Definitions: The desired tool motion command - triggered from the MMC or PLC - is not possible. The specified magazine location
is not contained in the specified magazine.
Reaction: NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy: Check whether the magazine data have been defined correctly.
Program Clear alarm with the Delete key or NC START.
Continuation:
Alarms
Diagnostics Manual, 07/2010, 6FC5398-8BP40-0BA0
NCK alarms
55