Block %2: Approach Or Retract Mode Incorrectly Defined; Block %2: Approach Or Retract Path = 0; Block %2: %]Active Tool Radius <= 0; Block %2: Length Or Width = 0 - Siemens Sinamics S120 Diagnostic Manual
Hide thumbs
Also See for Sinamics S120:
- Function manual (1094 pages) ,
- Manual (848 pages) ,
- Equipment manual (570 pages)
Table of Contents
Advertisement
NCK alarms
61115
[Channel %1: ] Block %2: Approach or retract mode(straight / circle / plane / space)
incorrectly defined
Parameters:
%1 = Channel number
%2 = Block number, label
Definitions:
The approach or retract mode to/from the contour has been incorrectly defined. Alarm triggered by following cycle:
CYCLE72.
Reaction:
Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy:
Check parameter _AS1 or _AS2.
Program
Clear alarm with the RESET key. Restart part program
Continuation:
61116
[Channel %1: ] Block %2: Approach or retract path = 0
Parameters:
%1 = Channel number
%2 = Block number, label
Definitions:
The approach or retract path has been specified with zero. Alarm triggered by following cycle: CYCLE72.
Reaction:
Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy:
Check parameter _LP1 or _LP2.
Program
Clear alarm with the RESET key. Restart part program
Continuation:
61117
%[[Channel %1: ] Block %2: %]Active tool radius <= 0
Parameters:
%1 = Channel number
%2 = Block number, label
Definitions:
The radius of the active tool is negative or zero. Alarm is triggered by the following cycles: CYCLE63, CYCLE71,
POCKET3, POCKET4.
Reaction:
Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy:
Modify radius.
Program
Clear alarm with the RESET key. Restart part program
Continuation:
61118
[Channel %1: ] Block %2: Length or width = 0
Parameters:
%1 = Channel number
%2 = Block number, label
Definitions:
The length or width of the milling area is illegal. Alarm triggered by following cycle: CYCLE71.
Reaction:
Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy:
Check parameters _LENG and _WID.
388
Diagnostics Manual, 07/2010, 6FC5398-8BP40-0BA0
Alarms
Hide quick links:
Advertisement
Table of Contents
