Block %2 Invalid Value; Block %2 Digital Input/Comparator No. %3 Not Activated; Block %2 Digital Output No. %3 Not Activated - Siemens Sinamics S120 Diagnostic Manual

NCK alarms
Remedy: Please inform the authorized personnel/service department. Determine the input limits of the machine data and assign
a value within these limits.
Program Clear alarm with NC START or RESET key and continue the program.
Continuation:
17095 [Channel %1: ] Block %2 invalid value
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: An attempt was made to write an invalid value, e.g. zero, into a machine data.
Reaction: Correction block is reorganized.
Interface signals are set.
Alarm display.
Remedy: Correct the value assignment, e.g. a value within the value range not equal to zero.
Program Clear alarm with NC START or RESET key and continue the program.
Continuation:
17100 [Channel %1: ] Block %2 digital input/comparator no. %3 not activated
Parameters: %1 = Channel number
%2 = Block number, label
%3 = Input number
Definitions: Either an attempt was made to read a digital input n via the system variable $A_IN[n] and this input has not been acti-
vated via NCK MD10350 $MN_FASTIO_DIG_NUM_INPUTS; or to read a comparator input via system variable
$A_INCO[n] and this input belongs to a comparator which has not been activated.
Reaction: Correction block is reorganized.
Interface signals are set.
Alarm display.
Remedy: Please inform the authorized personnel/service department. Modify part program or machine data accordingly.
Program Clear alarm with NC START or RESET key and continue the program.
Continuation:
17110 [Channel %1: ] Block %2 digital output no. %3 not activated
Parameters: %1 = Channel number
%2 = Block number, label
%3 = No. of output
Definitions: An attempt was made to read or set a digital NCK output (connector X 121) via the system variable $A_OUT [n] with
the index [n] greater than the specified upper limit in MD10360 $MN_FASTIO_DIG_NUM_OUTPUTS.
Reaction: Correction block is reorganized.
Interface signals are set.
Alarm display.
Remedy: Program index [n] of the system variable $A_OUT [n] only between 0 and the value in MD10360
$MN_FASTIO_DIG_NUM_OUTPUTS.
Program Clear alarm with NC START or RESET key and continue the program.
Continuation:
270
Diagnostics Manual, 07/2010, 6FC5398-8BP40-0BA0
Alarms