Block %2 Conflict With Gwps; Block %2 Incorrect Value Range For Constant Cutting Speed; Block%2 Changing Reference Axis For Constant Cutting Speed Not Allowed - Siemens Sinamics S120 Diagnostic Manual

14824 [Channel %1: ] Block %2 conflict with GWPS
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: The functions of constant grinding wheel surface speed GWPS and constant cutting speed G96 S... have been acti-
vated at the same time for a spindle.
Reaction: Correction block is reorganized.
Interface signals are set.
Alarm display.
Remedy: Modify part program.
Program Clear alarm with NC START or RESET key and continue the program.
Continuation:
14840 [Channel %1: ] Block %2 incorrect value range for constant cutting speed
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: The programmed cutting speed is not within the input range
Input range metric: 0.01 to 9 999.99 [m/min]
Input range inch: 0.1 to 99 999.99 [inch/min]
Reaction: Correction block is reorganized.
Interface signals are set.
Alarm display.
Remedy: Program cutting speed under address S within the permissible range of values.
Program Clear alarm with NC START or RESET key and continue the program.
Continuation:
14850 [Channel %1: ] Block %2 changing the reference axis for a constant cutting speed not
allowed
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: The attempt was made via the SCC[AX] instruction to change the reference
axis for a constant cutting speed.
This is not allowed if the indicated axis is no geometry axis.
Reaction: Correction block is reorganized.
Local alarm reaction.
Interface signals are set.
Alarm display.
Remedy: Please inform authorized personnel/service.
When programming SCC[AX] indicate a geometry axis known in the channel.
Program Clear alarm with NC START or RESET key and continue the program.
Continuation:
Alarms
Diagnostics Manual, 07/2010, 6FC5398-8BP40-0BA0
NCK alarms
201