Topology: Comparison Power Unit Missing In The Actual Topology; Topology: Comparison Sensor Module Missing In The Actual Topology - Siemens Sinamics S120 Diagnostic Manual

SINAMICS alarms
201481 <location>Topology: Comparison power unit missing in the actual topology
Message value: Component number: %1
Drive object: All objects
Reaction: NONE
Acknowledge: NONE
Cause: The topology comparison has detected a power unit in the target topology that is not available in the actual topology.
Alarm value (r2124, interpret decimal):
Component number of the additional target components.
Remedy: - delete the drive belonging to the power unit in the commissioning software project and download the new configura-
tion to the drive unit.
- check that the actual topology matches the target topology and if required, change over.
- check DRIVE-CLiQ cables for interruption and contact problems.
- check the 24 V supply voltage.
- check that the power unit is working properly.
Note:
Under "Topology --> Topology view" the commissioning software offers improved diagnostics capability (e.g. setpoint/
actual value comparison).
201482 <location>Topology: Comparison Sensor Module missing in the actual topology
Message value: Component number: %1
Drive object: All objects
Reaction: NONE
Acknowledge: NONE
Cause: The topology comparison has detected a Sensor Module in the target topology that is not available in the actual topol-
ogy.
Alarm value (r2124, interpret decimal):
Component number of the additional target components.
Remedy: - re-configure the drive belonging to the Sensor Module in the commissioning software project (encoder configuration)
and download the new configuration to the drive unit.
- delete the drive belonging to the Sensor Module in the commissioning software project and download the new con-
figuration to the drive unit.
- check that the actual topology matches the target topology and if required, change over.
- check DRIVE-CLiQ cables for interruption and contact problems.
- check the 24 V supply voltage.
- check that the Sensor Module is working properly.
Note:
Under "Topology --> Topology view" the commissioning software offers improved diagnostics capability (e.g. setpoint/
actual value comparison).
550
Diagnostics Manual, 07/2010, 6FC5398-8BP40-0BA0
Alarms