Block %2: Angle Of Inclined Grinding Wheel Missing; Block %2: Incorrect Type Of Machining; Block %2: Additional Offsets Not Set; Block %2: Current Grinding Wheel Too Wide - Siemens Sinamics S120 Diagnostic Manual
Hide thumbs
Also See for Sinamics S120:
- Function manual (1094 pages) ,
- Manual (848 pages) ,
- Equipment manual (570 pages)
Table of Contents
Advertisement
NCK alarms
61517
[Channel %1: ] Block %2: Angle of inclined grinding wheel missing
Parameters:
%1 = Channel number
%2 = Block number, label channel number
Definitions:
The alarm can be triggered by the following grinding cycle: CYCLE416
Remedy:
Enter angle under $TC_TPG8
Program
Clear alarm with the RESET key. Restart part program
Continuation:
61518
[Channel %1: ] Block %2: Shoulder height of grinding wheel must be > grinding wheel
radius
Parameters:
%1 = Channel number
%2 = Block number, label channel number
Definitions:
The alarm can be triggered by the following grinding cycle: CYCLE432
Remedy:
Change shoulder height or grinding wheel radius
Program
Clear alarm with the RESET key. Restart part program
Continuation:
61519
%[[Channel %1: ] Block %2: %]Incorrect type of machining
Parameters:
%1 = Channel number
%2 = Block number, label channel number
Definitions:
The alarm can be triggered by the following grinding cycles: CYCLE63, CYCLE64, CYCLE410, CYCLE411,
CYCLE412, CYCLE413, CYCLE415, CYCLE952
Remedy:
Assign a value between 1 and 3 to parameter B_ART
Program
Clear alarm with the RESET key. Restart part program
Continuation:
61520
[Channel %1: ] Block %2: Additional offsets not set
Parameters:
%1 = Channel number
%2 = Block number, label channel number
Definitions:
The alarm can be triggered by the following grinding cycles: CYCLE413, CYCLE420, CYCLE433
Remedy:
Set MD18094 MM_NUM_CC_TDA_PARAM=10
Program
Clear alarm with the RESET key. Restart part program
Continuation:
61521
[Channel %1: ] Block %2: Current grinding wheel too wide
Parameters:
%1 = Channel number
%2 = Block number, label channel number
Definitions:
The alarm can be triggered by the following grinding cycles: CYCLE411, CYCLE415
Remedy:
Reduce width of grinding wheel
Program
Clear alarm with the RESET key. Restart part program
Continuation:
456
Diagnostics Manual, 07/2010, 6FC5398-8BP40-0BA0
Alarms
Hide quick links:
Advertisement
Table of Contents
