Vsm: Unknown Alarm; Tm54F: Sampling Time Invalid; Tm54F: Parameter Value Invalid; Tm54F: Commissioning Not Possible - Siemens Sinamics S120 Diagnostic Manual

Hide thumbs Also See for Sinamics S120:

Table of Contents

SINAMICS alarms

<location>VSM: Unknown alarm

Message value:

New message: %1

Drive object:

AFE_SINUMERIK_828, BIC_SINUMERIK_828, SIC_COMBI, SIC_SINUMERIK_828

Acknowledge:

A fault occurred on the Voltage Sensing Module (VSM) an alarm has occurred that cannot be interpreted by the Control

Unit firmware.

This can occur if the firmware on this component is more recent than the firmware on the Control Unit.

Alarm value (r2124, interpret decimal):

Alarm number.

If required, the significance of this new alarm can be read about in a more recent description of the Control Unit.

- replace the firmware on the Voltage Sensing Module by an older firmware version (r0148).

- upgrade the firmware on the Control Unit (r0018).

<location>TM54F: Sampling time invalid

Message value:

Drive object:

AFE_SINUMERIK_828, BIC_SINUMERIK_828, SERVO_COMBI, SERVO_SINUMERIK828, SIC_COMBI,

SIC_SINUMERIK_828, TM54F_MA, TM54F_SL

Acknowledge:

The set sampling time is invalid.

- not a multiple integer of the DP clock cycle.

Fault value (r0949, floating point):

Recommended valid sampling time.

Adapt the sampling time (e.g. set the recommended valid sampling time).

Table of Contents

Sinumerik 828d