Acknowledging Faults; Reference To Sinamics Parameters - Siemens Sinamics S120 Diagnostic Manual

System reactions
8.3 System reactions for SINAMICS alarms

Acknowledging faults

Specifies the default method of acknowledging faults after the cause has been removed.
Designation POWER ON
Description The fault is acknowledged by a POWER ON process (switch drive unit off and on again).
Note:
If this action has not removed the fault cause, the fault is displayed again immediately after power
up.
Designation IMMEDIATELY
Description After the fault has been removed, the alarm can be cleared by pressing the RESET key.

Reference to SINAMICS parameters

In the "Cause" and "Remedy" fields, for several alarms, reference is made to a SINAMICS
parameter.
The parameter number consists of a "p" or "r" as prefix, followed by a 4-digit number(xxxx)
and optionally an index, e.g. p0918[0...3].
References
A detailed description of the SINAMICS parameters is provided in the:
SINAMICS S120/S150 List Manual
938
Diagnostics Manual, 07/2010, 6FC5398-8BP40-0BA0
Alarms