Load Manual Tool %3, Duplo No. %2 Onto Spindle/Toolholder %4; Tool Management: Remove Manual Tool %3 From Spindle/Toolholder %2; Tool Management: Remove Manual Tool %3 From Buffer Location %2 - Siemens Sinamics S120 Diagnostic Manual

NCK alarms
17212 [Channel %1: ] Tool management: Load manual tool %3, duplo no. %2 onto spindle/
toolholder %4
Parameters: %1 = Channel number
%2 = Duplo no.
%3 = Tool identifier
%4 = Toolholder number (spindle number)
Definitions: Indicates that the specified manual tool must be loaded in the specified toolholder or spindle before the program con-
tinues. A manual tool is a tool whose data is known to the NCK but has not been assigned to a magazine location and
is, therefore, not fully accessible to the NCK for automatic tool change or, in most cases, to the machine either.
The specified manual tool can also be a tool in a multitool. In this case the multitool has to be changed.
Reaction: Alarm display.
Remedy: Make sure that the specified tool is loaded in the toolholder. The alarm is cleared automatically after PLC acknowl-
edgement of the tool change on command.
Program Alarm display showing cause of alarm disappears. No further operator action necessary.
Continuation:
17214 [Channel %1: ] Tool management: remove manual tool %3 from spindle/toolholder %2
Parameters: %1 = Channel number
%2 = Toolholder number (spindle number)
%3 = Tool identifier
Definitions: Indicates that the specified manual tool must be removed from the specified toolholder or spindle before the program
continues. A manual tool is a tool whose data is known to the NCK but has not been assigned to a magazine location
and is, therefore, not fully accessible to the NCK for automatic tool change or, in most cases, to the machine either.
The specified manual tool may be a tool in a multitool. In this case the multitool has to be removed.
Reaction: Alarm display.
Remedy: Make sure that the specified tool is removed from the toolholder. The alarm is cleared automatically after PLC acknowl-
edgement of the tool change on command. Manual tools can only be used efficiently if this is supported by the PLC
program.
Program Alarm display showing cause of alarm disappears. No further operator action necessary.
Continuation:
17215 [Channel %1: ] Tool management: Remove manual tool %3 from buffer location %2
Parameters: %1 = Channel number
%2 = Buffer location number
%3 = Tool identifier
Definitions: Indicates that the specified manual tool must be removed from the specified buffer location before the program con-
tinues. A manual tool is a tool whose data is known to the NCK but has not been assigned to a magazine location and
is, therefore, not fully accessible to the NCK for automatic tool change or, in most cases, to the machine either.
The specified manual tool may also be included in a multitool. In this case the multitool has to be removed.
Reaction: Alarm display.
Remedy: Make sure that the specified manual tool is removed from the buffer location. The alarm is cleared automatically after
PLC acknowledgment of the tool change OFF command. Manual tools can only be used efficiently if this is supported
by the PLC program.
Program Alarm display showing cause of alarm disappears. No further operator action necessary.
Continuation:
278
Diagnostics Manual, 07/2010, 6FC5398-8BP40-0BA0
Alarms