Siemens Sinamics S120 Diagnostic Manual page 913

/STOPRUN/ No. 119
Definitions: Stop run, that is the NCK stops automatically at a block
defined by the OPI.
Not permitted if
1. Control is not in Automatic.
/SINGLEAX_LIFTFASTOFF_MASTER/ No. 120
Definitions: Fast retraction with a single axis
Not permitted if:
The axis is not controlled by the PLC
/SINGLEAX_STOPLIFTOFF_MASTER/ No. 121
Definitions: Stop fast retraction with a single axis
Not permitted if:
The axis is not controlled by the PLC
and the single axis does not execute a fast retraction
/TEST_SYNC_ASYNC/ No. 122
Definitions: For test purposes only, and only in assert systems.
/START_LOCK/ No. 123
Definitions: PI _N_STRTLK Set global start disable
always permitted
/START_UNLOCK/ No. 124
Definitions: PI _N_STRTUL Reset global start disable
always permitted
/FASTMODESWITCHTOAHANDMODE/ No. 125
Definitions: Implicit change to JOG mode at the start of a "JOG motion" in Automatic
See also $MN_JOG_MODE_MASK
Not permitted if:
1. A channel has left the mode group on account of an interrupt.
2. Overstoring
Possible actions:
1. Cancel the program with the Reset button or wait until the interrupt has finished.
4. Deselect overstore
Alarms
Diagnostics Manual, 07/2010, 6FC5398-8BP40-0BA0
List of actions
913