Siemens Sinamics S120 Diagnostic Manual page 184

NCK alarms
Program Clear alarm with NC START or RESET key and continue the program.
Continuation:
14541 [Channel %1: ] Block %2 contour tool: the max. limit angle has been programmed more
than once (edge D%3)
Parameters: %1 = Channel number
%2 = Block number, label
%3 = Edge number, label
Definitions: The limit angle of a contour tool must be equal zero in an involved edge only.
Reaction: Correction block is reorganized.
Local alarm reaction.
Interface signals are set.
Alarm display.
NC Stop on alarm at block end.
Remedy: Change tool definition.
Program Clear alarm with NC START or RESET key and continue the program.
Continuation:
14542 [Channel %1: ] Block %2 contour tool: the min. limit angle has not been programmed
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: On defining a contour tool, either no limit angle must be indicated, or both the minimum and the maximum limit angle
must be programmed once for each.
Reaction: Correction block is reorganized.
Local alarm reaction.
Interface signals are set.
Alarm display.
NC Stop on alarm at block end.
Remedy: Change tool definition.
Program Clear alarm with NC START or RESET key and continue the program.
Continuation:
14543 [Channel %1: ] Block %2 contour tool: the max. limit angle has not been programmed
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: On defining a contour tool, either no limit angle must be indicated, or both the minimum and the maximum limit angle
must be programmed once for each.
Reaction: Correction block is reorganized.
Local alarm reaction.
Interface signals are set.
Alarm display.
NC Stop on alarm at block end.
Remedy: Change tool definition.
Program Clear alarm with NC START or RESET key and continue the program.
Continuation:
184
Diagnostics Manual, 07/2010, 6FC5398-8BP40-0BA0
Alarms