NCK alarms
61613
[Channel %1: ] Block %2: Undercut position incorrectly defined
Parameters:
%1 = Channel number
%2 = Block number, label
Definitions:
Alarm triggered by following cycles: CYCLE94, CYCLE96.
Reaction:
Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy:
Check value in parameter _VARI.
Program
Clear alarm with the RESET key. Restart part program
Continuation:
61614
[Channel %1: ] Block %2: %4 Z mirroring in WO for main spindle not permitted
Parameters:
%1 = Channel number
%2 = Block number, label
Definitions:
WO for main spindle machining must not have Z mirroring.
Alarm is triggered by the following cycles: CYCLE209, F_HEAD
Reaction:
Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy:
Deselect Z mirroring in the WO used.
Program
Clear alarm with the RESET key. Restart part program
Continuation:
61700
%[[Channel %1: ] Block %2: %]Name of program to be generated is missing
Parameters:
%1 = Channel number
%2 = Block number, label
Definitions:
Alarm triggered by following cycle: CYCLE952
Reaction:
Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy:
- Check parameter PRG
Program
Clear alarm with the RESET key. Restart part program
Continuation:
61701
%[[Channel %1: ] Block %2: %]Contour %4 does not exist
Parameters:
%1 = Channel number
%2 = Block number, label
Definitions:
Alarm triggered by following cycle: CYCLE952
Reaction:
Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
466
Diagnostics Manual, 07/2010, 6FC5398-8BP40-0BA0
Alarms