Topology: Actual Topology Changed; Topology: Defective Components In Actual Topology - Siemens Sinamics S120 Diagnostic Manual

201355 <location>Topology: Actual topology changed
Message value: %1
Drive object: All objects
Reaction: NONE
Acknowledge: IMMEDIATELY
Cause: The device target topology (p0099) does not correspond to the device actual topology (r0098).
The fault only occurs if the topology was commissioned using the automatic internal device mechanism and not using
the commissioning software.
Fault value (r0949, interpret decimal):
Only for internal Siemens troubleshooting.
See also: r0098 (Actual device topology), p0099 (Device target topology)
Remedy: One of the following counter-measures can be selected if no faults have occurred in the topology detection itself:
If commissioning is still not completed:
- carry out a self-commissioning routine (starting from p0009 = 1).
In general:
Set p0099 = r0098, set p0009 = 0; for existing Motor Modules, this results in servo drives being automatically gener-
ated (p0107).
Generating servo drives: Set p0097 to 1, set p0009 to 0.
Generating vector drives: Set p0097 to 2, set p0009 to 0.
Generating vector drives with parallel circuit: Set p0097 to 12, set p0009 to 0.
In order to set configurations in p0108, before setting p0009 to 0, it is possible to first set p0009 to 2 and modify p0108.
The index corresponds to the drive object (p0107).
If commissioning has already been completed:
- re-establish the original connections and re-connect power to the Control Unit.
- restore the factory setting for the complete equipment (all of the drives) and allow automatic self-commissioning
again.
- change the device parameterization to match the connections (this is only possible using the commissioning soft-
ware).
Notice:
Topology changes that result in this fault being generated cannot be accepted by the automatic function in the device,
but must be transferred using the commissioning software and parameter download. The automatic function in the
device only allows constant topology to be used. Otherwise, when the topology is changed, all of the previous param-
eter settings are lost and replaced by the factory setting.
See also: r0098 (Actual device topology)
201356 <location>Topology: Defective components in actual topology
Message value: Fault cause: %1, Component number: %2, Connection number: %3
Drive object: All objects
Reaction: OFF2
Acknowledge: IMMEDIATELY
Cause: The actual topology indicates at least one defective DRIVE-CLiQ component.
Fault value (r0949, interpret hexadecimal):
zzyyxx hex:
zz = connection number of component before the defective component
yy = component number of component before the defective component
xx = fault cause
xx = 1: Component at this Control Unit not permissible.
Note:
Pulse enable is withdrawn and prevented.
Remedy: Remove the defective components and restart the system.
Alarms
Diagnostics Manual, 07/2010, 6FC5398-8BP40-0BA0
SINAMICS alarms
537