Block %2: Center And Radius Cannot Be Determined; Block %2: Check Number Of Circle Calculation Points; Block %2: Check Weighting Factor; Block %2: Check Call Parameter Cycle114/Block %2: Check Tool Number - Siemens Sinamics S120 Diagnostic Manual

NCK alarms
61316 [Channel %1: ] Block %2: Center and radius cannot be determined
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: No circle can be calculated from the measured points, as all measured points lie on a straight line.
The alarm is triggered by: CYCLE979
Remedy: Program change
61317 [Channel %1: ] Block %2: Check number of circle calculation points
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: Parameterization faulty; requires 3 or 4 points to calculate the center point. Alarm is triggered: CYCLE979.
Remedy: Change parameterization of CYCLE116.
61318 [Channel %1: ] Block %2: Check weighting factor
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: Alarm is triggered: CYCLE974, CYCLE977, CYCLE978, CYCLE979, CYCLE994, CYCLE998.
Remedy: Check parameter (_K).
61319 [Channel %1: ] Block %2: Check call parameter CYCLE114
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: Internal error in measuring cycles. Alarm is triggered: CYCLE974, CYCLE977, CYCLE978, CYCLE979, CYCLE994,
CYCLE998.
Remedy: Check call parameter CYCLE114.
61320 [Channel %1: ] Block %2: Check tool number
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: Alarm can be triggered by following measuring cycles: all measuring cycles.
Remedy: For 840D:
- Check parameters _TNUM, _TNAME.
Bei 840D sl:
- Check parameter T.
With active tool management, parameter T=0 (_TNUM=0 ), and parameter _TNAME is empty or
the specified tool name is unknown to the tool management.
434
Diagnostics Manual, 07/2010, 6FC5398-8BP40-0BA0
Alarms