Infeed In Z Direction Too Big Per Stroke, Or Wheel Too Narrow; Block %2: Feed Left Wheel Edge <=0; Block %2: Feed Right Wheel Edge <=0; Block %2: Feed On The Diameter <=0 - Siemens Sinamics S120 Diagnostic Manual
Hide thumbs
Also See for Sinamics S120:
- Function manual (1094 pages) ,
- Manual (848 pages) ,
- Equipment manual (570 pages)
Table of Contents
Advertisement
NCK alarms
61559
[Channel %1: ] Block %2: Chamfer / radius + shoulder height are less than the
retraction height of the right edge of the grinding wheel
Parameters:
%1 = Channel number
%2 = Block number, label channel number
Definitions:
The alarm can be triggered by the following grinding cycle: CYCLE432
Remedy:
Check values in grinding wheel data
Program
Clear alarm with the RESET key. Restart part program
Continuation:
61560
[Channel %1: ] Block %2: Infeed in Z direction too big per stroke, or wheel too narrow
Parameters:
%1 = Channel number
%2 = Block number, label channel number
Definitions:
The alarm can be triggered by the following grinding cycles: CYCLE427, CYCLE428
Remedy:
Reduce infeed path parameter or use other tool
Program
Clear alarm with the RESET key. Restart part program
Continuation:
61561
[Channel %1: ] Block %2: Feed left wheel edge <=0
Parameters:
%1 = Channel number
%2 = Block number, label channel number
Definitions:
The alarm can be triggered by the following grinding cycle: CYCLE432
Remedy:
Check values in grinding wheel data
Program
Clear alarm with the RESET key. Restart part program
Continuation:
61562
[Channel %1: ] Block %2: Feed right wheel edge <=0
Parameters:
%1 = Channel number
%2 = Block number, label channel number
Definitions:
The alarm can be triggered by the following grinding cycle: CYCLE432
Remedy:
Check values in grinding wheel data
Program
Clear alarm with the RESET key. Restart part program
Continuation:
61563
[Channel %1: ] Block %2: Feed on the diameter <=0
Parameters:
%1 = Channel number
%2 = Block number, label channel number
Definitions:
The alarm can be triggered by the following grinding cycle: CYCLE432
Remedy:
Check values in grinding wheel data
Program
Clear alarm with the RESET key. Restart part program
Continuation:
462
Diagnostics Manual, 07/2010, 6FC5398-8BP40-0BA0
Alarms
Hide quick links:
Advertisement
Table of Contents
