Block %2 Transformation Active At Geometry Axis Changeover; Block %2 Fine Tool Correction; Block %2 Geoax Function: Incorrect Call - Siemens Sinamics S120 Diagnostic Manual

14412 [Channel %1: ] Block %2 transformation active at geometry axis changeover
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: It is not permissible to change the assignment of geometry axes to channel axes when transformation is active.
Reaction: Correction block is reorganized.
Interface signals are set.
Alarm display.
Remedy: Modify part program.
Program Clear alarm with NC START or RESET key and continue the program.
Continuation:
14413 [Channel %1: ] Block %2 fine tool correction: changeover geometry/channel axis not
allowed
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: It is not permissible to change the assignment of geometry axes to channel axes during active tool fine compensation.
Reaction: Correction block is reorganized.
Interface signals are set.
Alarm display.
Remedy: Modify part program.
Program Clear alarm with NC START or RESET key and continue the program.
Continuation:
14414 [Channel %1: ] Block %2 GEOAX function: incorrect call
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: The parameters for calling the GEOAX(...) are incorrect. Possible causes:
- Uneven number of parameters.
- More than 6 parameters were specified.
- A geometry axis number was programmed which was less than 0 or greater than 3.
- A geometry axis number was programmed more than once.
- An axis identifier was programmed more than once.
- An attempt was made to assign a channel axis to a geometry axis which has the same name as one of the channel
axes.
- An attempt was made to assign a channel axis to a geometry axis lacking IPO functionality (see MD30460
$MA_BASE_FUNCTION_MASK, Bit8).
- An attempt was made to remove a geometry axis with the same name as one of the channel axes from the geometry
axis grouping.
Reaction: Correction block is reorganized.
Interface signals are set.
Alarm display.
Remedy: Modify part program or correction block.
Program Clear alarm with NC START or RESET key and continue the program.
Continuation:
Alarms
Diagnostics Manual, 07/2010, 6FC5398-8BP40-0BA0
NCK alarms
181