Block %2: Multi-Channel Data Not Found In Job List: %4; Block %2: 1St Spindle Not Programmed; Block %2: Spindle Programmed Twice - Siemens Sinamics S120 Diagnostic Manual

NCK alarms
Remedy: - select shorter label name
Program Clear alarm with the RESET key. Restart part program
Continuation:
61048 [Channel %1: ] Block %2: Multi-channel data not found in job list: %4
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: Alarm triggered by following cycle: CYCLE208
Reaction: Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy: Multi-channel data not found in job list.
Correct job list.
Program Clear alarm with the RESET key. Restart part program
Continuation:
61049 [Channel %1: ] Block %2: 1st spindle not programmed
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: The alarm was triggered by the following cycles: CYCLE209
First spindle in mask was not programmed.
Reaction: Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy: Program 1st spindle in the mask.
Program Clear alarm with the RESET key. Restart part program
Continuation:
61050 [Channel %1: ] Block %2: Spindle programmed twice
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: Alamr was triggered by the following cycles: CYCLE209
The same spindle was programmed twice.
Reaction: Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy: Leave 2nd spindle empty or program other spindle.
Program Clear alarm with the RESET key. Restart part program
Continuation:
382
Diagnostics Manual, 07/2010, 6FC5398-8BP40-0BA0
Alarms