Block %2 Parameter Is Zero Or Missing; Block %2 Parameter Is Not Relevant; Block %2 Too Many Couplings For Axis/Spindle %3 - Siemens Sinamics S120 Diagnostic Manual

NCK alarms
Reaction: Correction block is reorganized.
Interface signals are set.
Alarm display.
Remedy: Check in the part program whether another link already exists for the axes.
Program Clear alarm with NC START or RESET key and continue the program.
Continuation:
16790 [Channel %1: ] Block %2 Parameter is zero or missing
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: A coupling has been switched on in which a relevant parameter has been specified with zero or has not been written
(e.g. denominator in the transmission ratio, no slave axis).
Reaction: Correction block is reorganized.
Interface signals are set.
Alarm display.
Remedy: Please inform the authorized personnel/service department.
- Configure link accordingly in SD42300 $SC_COUPLE_RATIO_1
- or correct part program.
Program Clear alarm with NC START or RESET key and continue the program.
Continuation:
16791 [Channel %1: ] Block %2 parameter is not relevant
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: A coupling has been switched on in which a non-relevant parameter has been written (e.g. parameter for ELG).
Reaction: Correction block is reorganized.
Interface signals are set.
Alarm display.
Remedy: Modify part program.
Program Clear alarm with NC START or RESET key and continue the program.
Continuation:
16792 [Channel %1: ] Block %2 too many couplings for axis/spindle %3
Parameters: %1 = Channel number
%2 = Block number, label
%3 = Axis name, spindle number
Definitions: For the specified axis/spindle, more master axes/spindles have been defined than are allowed.
Reaction: Correction block is reorganized.
Interface signals are set.
Alarm display.
Remedy: Modify part program.
Program Clear alarm with NC START or RESET key and continue the program.
Continuation:
246
Diagnostics Manual, 07/2010, 6FC5398-8BP40-0BA0
Alarms