Block %3 Spindle %2 Configured Positioning Speed Is Too High; Block %2 For Following Spindle %3 Coupling Already Existing; Block %2 For Leading Spindle %3 Coupling Already Existing - Siemens Sinamics S120 Diagnostic Manual

Remedy: Modify setting of MD34200 $MA_ENC_REFP_MODE or change to JOG+REF and then reference.
Program Clear alarm with the RESET key. Restart part program
Continuation:
22055 [Channel %1: ] Block %3 spindle %2 configured positioning speed is too high
Parameters: %1 = Channel number
%2 = Axis name, spindle number
%3 = Block number, label
Definitions: The current position is not referenced with the measuring system position although reference is made to it.
Reaction: Alarm display.
Remedy: Correct NC part program. Create the zero mark synchronization by positioning, by rotation (at least 1 revolution) in
speed control mode or G74 before switching the alarm generating function on.
Program Clear alarm with the Delete key or NC START.
Continuation:
22057 [Channel %1: ] Block %2 for following spindle %3 coupling as leading spindle/axis
already existing
Parameters: %1 = Channel number
%2 = Block number, label
%3 = Axis name, spindle number
Definitions: A coupling has been switched on in which the following spindle/axis has already been active as leading spindle/axis
in another coupling. Chained couplings cannot be processed.
Reaction: NC Start disable in this channel.
Interface signals are set.
Alarm display.
NC Stop on alarm.
Remedy: Check in the parts program whether the following spindle/axis is already active as leading spindle/axis in another cou-
pling.
Program Clear alarm with the RESET key. Restart part program
Continuation:
22058 [Channel %1: ] Block %2 for leading spindle %3 coupling as following spindle/axis
already existing
Parameters: %1 = Channel number
%2 = Block number, label
%3 = Axis name, spindle number
Definitions: A coupling has been switched on in which the leading spindle/axis has already been active as following spindle/axis
in another coupling. Chained couplings cannot be processed.
Reaction: NC Start disable in this channel.
Interface signals are set.
Alarm display.
NC Stop on alarm.
Remedy: Check in the parts program whether the leading spindle/axis is already active as following spindle/axis in another cou-
pling.
Program Clear alarm with the RESET key. Restart part program
Continuation:
Alarms
Diagnostics Manual, 07/2010, 6FC5398-8BP40-0BA0
NCK alarms
335