Block %2: External Tool Diameter Too Small; Block %2: %]Chamfer Width Too Small; Block %2: %]Chamfer Width - Tool Radius - Siemens Sinamics S120 Diagnostic Manual

NCK alarms
Remedy: The machining direction must be selected to match the delimitations.
Program Clear alarm with the RESET key. Restart part program
Continuation:
61269 [Channel %1: ] Block %2: External tool diameter too small
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: Incorrect tool definition.
Alarm triggered by following cycle: CYCLE61.
Reaction: Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy: Check angle and diameter of the tool used.
Program Clear alarm with the RESET key. Restart part program
Continuation:
61270 %[[Channel %1: ] Block %2: %]Chamfer width too small
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: Chamfer width selected too small.
Alarm triggered by the following cycles: E_SP_CHA, F_SP_CHA.
Reaction: Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy: Increase the chamfer width.
Program Clear alarm with the RESET key. Restart part program
Continuation:
61271 %[[Channel %1: ] Block %2: %]Chamfer width > tool radius
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: Chamfer width larger than tool radius.
Alarm triggered by following cycles: E_SP_CHA, F_SP_CHA.
Reaction: Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy: Use a larger tool.
Program Clear alarm with the RESET key. Restart part program
Continuation:
422
Diagnostics Manual, 07/2010, 6FC5398-8BP40-0BA0
Alarms