Block %2: Orientation Of Tool Not Possible - Error Code: %4; No 'Rotary Axes Direct' Swivel Mode Possible - Error Code: %2; Block %2: %] Final Depth Wrongly Programmed; Block %2: Unit For Plane Infeed Wrongly Programmed - Siemens Sinamics S120 Diagnostic Manual
Hide thumbs
Also See for Sinamics S120:
- Function manual (1094 pages) ,
- Manual (848 pages) ,
- Equipment manual (570 pages)
Table of Contents
Advertisement
61151
[Channel %1: ] Block %2: Orientation of tool not possible --> error code: %4
Parameters:
%1 = Channel number
%2 = Block number, label
Definitions:
Alarm triggered by following cycle: CYCLE800.
Remedy:
Causes of error:
1st error code = A -> only additive swivel plane permitted, see parameter _ST
61152
[Channel %1: ] Block %2: B axis kinematics (turning technology) either not or
incorrectly set up in Start-up of swivel cycle --> error code: %4
Parameters:
%1 = Channel number
%2 = Block number, label
Definitions:
Alarm triggered by following cycle: CYCLE800.
Remedy:
Causes of error:
1st error code = A123 -> B axis not an automatic rotary axis under ShopTurn (123 corresponds to parameter _TCBA)
2nd error code = B123 -> B axis not activated in swiveling start-up (kinematics)
61153
[Channel %1: ] Block %2: No 'Rotary axes direct' swivel mode possible --> error code:
%4
Parameters:
%1 = Channel number
%2 = Block number, label
Definitions:
Alarm triggered by following cycle: CYCLE800.
Remedy:
Causes of error:
1st error code = A -> No tool or cutting edge (D1..) active
61154
%[[Channel %1: ] Block %2: %]Final depth wrongly programmed
Parameters:
%1 = Channel number
%2 = Block number, label channel number
Definitions:
The alarm is triggered by the following cycle: CYCLE63, CYCLE64, CYCLE899
Remedy:
Input of end depth possible only absolutely or incrementally
61155
[Channel %1: ] Block %2: Unit for plane infeed wrongly programmed
Parameters:
%1 = Channel number
%2 = Block number, label channel number
Definitions:
The alarm is triggered by the following cycle: CYCLE899
Remedy:
Unit for plane infeed possible only in mm or % of tool diameter
61156
[Channel %1: ] Block %2: Depth calculation wrongly programmed
Parameters:
%1 = Channel number
%2 = Block number, label channel number
Definitions:
The alarm is triggered by the following cycle: CYCLE899
Remedy:
Depth calculation possible only with or without SDIS
Alarms
Diagnostics Manual, 07/2010, 6FC5398-8BP40-0BA0
(123 corresponds to $TC_CARR37[n], n ... number of the swivel data record)
NCK alarms
395
Hide quick links:
Advertisement
Table of Contents
