Siemens Sinamics S120 Diagnostic Manual page 185

14544 [Channel %1: ] Block %2 contour tool: edge D%3 is not positioned between the two
border edges
Parameters: %1 = Channel number
%2 = Block number, label
%3 = Edge number, label
Definitions: On defining a form tool with limit, all edges must be positioned between the edge with the minimum limit angle and the
edge with the maximum limit angle when rotating counter-clockwise.
Reaction: Correction block is reorganized.
Local alarm reaction.
Interface signals are set.
Alarm display.
NC Stop on alarm at block end.
Remedy: Change tool definition.
Program Clear alarm with NC START or RESET key and continue the program.
Continuation:
14545 [Channel %1: ] Block %2 contour tool: edge D%3 completely encircles edge D%4
Parameters: %1 = Channel number
%2 = Block number, label
%3 = Edge number, label
%4 = Edge number, label
Definitions: On defining a contour tool, tangents are placed on the adjacent circular edges. It will not be possible, if one edge is
completely encircled by another one.
Reaction: Correction block is reorganized.
Local alarm reaction.
Interface signals are set.
Alarm display.
NC Stop on alarm at block end.
Remedy: Change tool definition.
Program Clear alarm with NC START or RESET key and continue the program.
Continuation:
14546 [Channel %1: ] Block %2 contour tool: edge D%3 defines a concave corner
Parameters: %1 = Channel number
%2 = Block number, label
%3 = Edge number, label
Definitions: The contour of a contour tool must be convex throughout, i.e. there must not be any concave corners.
Reaction: Correction block is reorganized.
Local alarm reaction.
Interface signals are set.
Alarm display.
NC Stop on alarm at block end.
Remedy: Change tool definition.
Program Clear alarm with NC START or RESET key and continue the program.
Continuation:
Alarms
Diagnostics Manual, 07/2010, 6FC5398-8BP40-0BA0
NCK alarms
185