Block %2 Following Spindle/Axis %3 Not Available; Block %2 Master Spindle/Axis %3 Not Available; Block %2 Identical Spindles/Axes %3 - Siemens Sinamics S120 Diagnostic Manual

NCK alarms
Reaction: Correction block is reorganized.
Interface signals are set.
Alarm display.
Remedy: Modify part program.
Program Clear alarm with NC START or RESET key and continue the program.
Continuation:
16782 [Channel %1: ] Block %2 following spindle/axis %3 not available
Parameters: %1 = Channel number
%2 = Block number, label
%3 = Axis name, spindle number
Definitions: A coupling has been switched on in which the slave spindle/axis is currently not available. Possible causes:
- The spindle/axis is active in the other channel.
- The spindle/axis has been accessed by the PLC and has not yet been released.
Reaction: Correction block is reorganized.
Interface signals are set.
Alarm display.
Remedy: Please inform the authorized personnel/service department. Put the master spindle/axis with spindle/axis exchange
into the necessary channel or release from the PLC.
Program Clear alarm with NC START or RESET key and continue the program.
Continuation:
16783 [Channel %1: ] Block %2 master spindle/axis %3 not available
Parameters: %1 = Channel number
%2 = Block number, label
%3 = Axis name, spindle number
Definitions: A coupling has been switched on in which the master spindle/axis is currently not available. Possible causes:
- Setpoint linkage has been selected and spindle/axis is active in the other channel.
- The spindle/axis has been accessed by the PLC and has not yet been released.
Reaction: Correction block is reorganized.
Interface signals are set.
Alarm display.
Remedy: Please inform the authorized personnel/service department. Put the master spindle/axis with spindle/axis exchange
into the necessary channel or release from the PLC.
Program Clear alarm with NC START or RESET key and continue the program.
Continuation:
16785 [Channel %1: ] Block %2 identical spindles/axes %3
Parameters: %1 = Channel number
%2 = Block number, label
%3 = Axis name, spindle number
Definitions: A coupling has been switched on in which the following spindle/axis is identical to the master spindle/axis.
Reaction: Correction block is reorganized.
Interface signals are set.
Alarm display.
Remedy: Please inform the authorized personnel/service department.
- Configure link accordingly in MD21300 $MC_COUPLE_AXIS_1
- or modify part program.
Program Clear alarm with NC START or RESET key and continue the program.
Continuation:
244
Diagnostics Manual, 07/2010, 6FC5398-8BP40-0BA0
Alarms