Block %2 Too Many Machine Data %3; Block %2 Too Many Tool Parameters %3 - Siemens Sinamics S120 Diagnostic Manual

NCK alarms
12510 [Channel %1: ] Block %2 too many machine data %3
Parameters: %1 = Channel number
%2 = Block number, label
%3 = Source symbol
Definitions: In the part program, in the machine data file (..._TEA) and in the initialization file (..._INI), no more than 5 machine data
may be used per block.
Example:
N ...
N 100 $MN_OVR_FACTOR_FEEDRATE [10] = 15,
N ...
Reaction: Correction block is reorganized.
Interface signals are set.
Alarm display.
Remedy: Press the NC Stop key and select the function "Correction block" with the softkey PROGRAM CORRECT. The cor-
rection pointer positions on the incorrect block.
- Divide up the part program block into several blocks.
- If necessary, use the local variable for storing intermediate results.
Program Clear alarm with NC START or RESET key and continue the program.
Continuation:
12520 [Channel %1: ] Block %2 too many tool parameters %3
Parameters: %1 = Channel number
%2 = Block number, label
%3 = Source symbol
Definitions: In the part program, in the tool offset file (..._TOA) and in the initialization file (..._INI), no more than 5 tool offset param-
eters may be used per block.
Example:
N ...
N 100 $TC_DP1 [5,1] = 130, $TC_DP3 [5,1] = 150.123,
N ...
Reaction: Correction block is reorganized.
Interface signals are set.
Alarm display.
Remedy: Press the NC Stop key and select the function "Correction block" with the softkey PROGRAM CORRECT. The cor-
rection pointer positions on the incorrect block.
- Divide up the part program block into several blocks.
- If necessary, use the local variable for storing intermediate results.
Program Clear alarm with NC START or RESET key and continue the program.
Continuation:
128
$MN_OVR_FACTOR_FEEDRATE [11] = 20
$TC_DP4 [5,1] = 223.4, $TC_DP5 [5,1] = 200.12,
$TC_DP6 [5,1] = 55.02
Diagnostics Manual, 07/2010, 6FC5398-8BP40-0BA0
Alarms