Block %2: No D Number Active; Block %2: Check Measuring Cycle Number/Block %2: Check Probe Number; Block %2: Check Selected Tool Type; Block %2: Check Position Of Cutting Edge - Siemens Sinamics S120 Diagnostic Manual

61311 [Channel %1: ] Block %2: No D number active
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: No tool offset for the measuring probe (for workpiece measurement) or no tool offset for the active tool (for tool mea-
surement) is selected.
Alarm can be triggered by the following measuring cycles: all measuring cycles.
Remedy: Select the tool's tool edge number D.
61312 [Channel %1: ] Block %2: Check measuring cycle number
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: The alarm can be triggered by the following measuring cycles: all measuring cycles.
Remedy: Measuring cycle called is impermissible...
61313 [Channel %1: ] Block %2: Check probe number
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: Alarm can be triggered by following measuring cycles: all measuring cycles.
Remedy: Check parameter _PRNUM in connection with the following data fields and machine data:
For 840D:
- Create data field _WP[], _TP[] and _TPW[] for additional tool or workpiece probe
and adjust _CVAL[0]/_CVAL[1] accordingly.
Bei 840D sl:
- Check the following machine data: 51600 $MNS_MEA_CAL_WP_NUM, 51602 $MNS_MEA_CAL_TP_NUM and
51603 $MNS_MEA_CAL_TPW_NUM
61314 [Channel %1: ] Block %2: Check selected tool type
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: Alarm is triggered: CYCLE971, CYCLE972, CYCLE982.
Remedy: Tool type impermissible for tool measurement/tool probe calibration.
61315 [Channel %1: ] Block %2: Check position of cutting edge
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: Alarm is triggered: CYCLE972, CYCLE973, CYCLE974, CYCLE982, CYCLE994.
Remedy: Check tool edge position (probe) in TO memory.
Alarms
Diagnostics Manual, 07/2010, 6FC5398-8BP40-0BA0
NCK alarms
433