Assign Parameters For Counterspindle Chuck In The Spindle Chuck Data; Block %2: Program Contains New Machining Steps From Shopmill %4; Block %2: Program Contains New Machining Steps From Shopturn %4; Block %2: Center Offset Too Large - Siemens Sinamics S120 Diagnostic Manual
Hide thumbs
Also See for Sinamics S120:
- Function manual (1094 pages) ,
- Manual (848 pages) ,
- Equipment manual (570 pages)
Table of Contents
Advertisement
61258
[Channel %1: ] Block %2: Assign parameters for counterspindle chuck in the spindle
chuck data
Parameters:
%1 = Channel number
%2 = Block number, label
Definitions:
The parameters for the counterspindle chuck in the spindle chuck data have not been assigned.
The alarm is triggered by the following cycles: F_SUB_SP.
Reaction:
Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy:
Indicate parameters ZCn, ZSn and ZEn in the mask "Parameters" > "Setting data" > "Spindle chuck data".
Program
Clear alarm with the RESET key. Restart part program
Continuation:
61259
[Channel %1: ] Block %2: program contains new machining steps from ShopMill %4
Parameters:
%1 = Channel number
%2 = Block number, label
%4 = ShopMill version
Definitions:
The program has been created with a ShopMill version that is higher than the existing one.
Reaction:
Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy:
Delete the machining step and reprogram machining if required.
Program
Clear alarm with the RESET key. Restart part program
Continuation:
61260
[Channel %1: ] Block %2: program contains new machining steps from ShopTurn %4
Parameters:
%1 = Channel number
%2 = Block number, label
%4 = ShopTurn version
Definitions:
The program has been created with a ShopMill version that is higher than the existing one.
Reaction:
Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy:
Delete the machining step and reprogram machining if required.
Program
Clear alarm with the RESET key. Restart part program
Continuation:
61261
[Channel %1: ] Block %2: center offset too large
Parameters:
%1 = Channel number
%2 = Block number, label
Definitions:
The center offset on center drilling is larger than permissible.
Alarm triggered by following cycles: F_DRILL, F_DRILLD.
Alarms
Diagnostics Manual, 07/2010, 6FC5398-8BP40-0BA0
NCK alarms
419
Hide quick links:
Advertisement
Table of Contents
