Block %2: Infeed Width - Tool Diameter; Block %2: Tool Radius Negative; Block %2: Parameter For Corner Radius Too Large; Block %2: Machining Direction G41/G42 Incorrectly Defined - Siemens Sinamics S120 Diagnostic Manual
Hide thumbs
Also See for Sinamics S120:
- Function manual (1094 pages) ,
- Manual (848 pages) ,
- Equipment manual (570 pages)
Table of Contents
Advertisement
61111
[Channel %1: ] Block %2: Infeed width > Tool diameter
Parameters:
%1 = Channel number
%2 = Block number, label
Definitions:
The programmed infeed width is greater than the diameter of the active tool. Alarm triggered by following cycles:
CYCLE71, POCKET3, POCKET4.
Reaction:
Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy:
Infeed width must be reduced.
Program
Clear alarm with the RESET key. Restart part program
Continuation:
61112
[Channel %1: ] Block %2: Tool radius negative
Parameters:
%1 = Channel number
%2 = Block number, label
Definitions:
The radius of the active tool is negative. This is illegal. Alarm triggered by following cycles: CYCLE72, CYCLE76,
CYCLE77, CYCLE90.
Remedy:
Change the tool radius.
Program
Clear alarm with the RESET key. Restart part program
Continuation:
61113
[Channel %1: ] Block %2: Parameter for corner radius too large
Parameters:
%1 = Channel number
%2 = Block number, label
Definitions:
The parameter for the corner radius _CRAD has been specified too large. Alarm triggered by following cycle:
POCKET3.
Reaction:
Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy:
Reduce corner radius
Program
Clear alarm with the RESET key. Restart part program
Continuation:
61114
[Channel %1: ] Block %2: Machining direction G41/G42 incorrectly defined
Parameters:
%1 = Channel number
%2 = Block number, label
Definitions:
The machining direction of the cutter radius compensation G41/G42 has been incorrectly selected. Alarm triggered by
following cycle: CYCLE72.
Reaction:
Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy:
Change machining direction.
Program
Clear alarm with the RESET key. Restart part program
Continuation:
Alarms
Diagnostics Manual, 07/2010, 6FC5398-8BP40-0BA0
NCK alarms
387
Hide quick links:
Advertisement
Table of Contents
