Block %2 Command Not Allowed With Ftocon; Block %2 Ftocon Not Allowed; Block %2 Invalid Spindle Number With Putftocf; Block %2 Spline And Polynominal Interpolation Not Available - Siemens Sinamics S120 Diagnostic Manual

16130 [Channel %1: ] Block %2 command not allowed with FTOCON
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: - Case 1: A plane change is not allowed if the modal G function FTOCON: "fine tool compensation" is active.
- Case 2: Transformation selection is allowed only for zero transformation or transformation inclined axis, Transmit or
Tracyl if FTOCON is active.
- Case 3: Tool change is not allowed with M06 if FTOCON has been active since the last tool change.
- Case 4: Orientable tool holder is active.
Reaction: Correction block is reorganized.
Interface signals are set.
Alarm display.
Remedy: Modify part program: Deselect fine tool compensation with FTOCOF.
Program Clear alarm with NC START or RESET key and continue the program.
Continuation:
16140 [Channel %1: ] Block %2 FTOCON not allowed
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: The tool fine compensation (FTOC) is not compatible with the currently active transformation.
Reaction: Correction block is reorganized.
Interface signals are set.
Alarm display.
Remedy: Modify part program: Deselect fine tool compensation with FTOCOF.
Program Clear alarm with NC START or RESET key and continue the program.
Continuation:
16150 [Channel %1: ] Block %2 invalid spindle number with PUTFTOCF
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: The spindle number programmed for PUTFTOC or PUTFTOCF is beyond the permitted range for the spindle numbers.
Reaction: Correction block is reorganized.
Interface signals are set.
Alarm display.
Remedy: Modify part program. Is the programmed spindle number available?
Program Clear alarm with NC START or RESET key and continue the program.
Continuation:
16200 [Channel %1: ] Block %2 spline and polynominal interpolation not available
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: The spline and polynomial interpolation are options that are not contained in the basic version of the control.
Reaction: Correction block is reorganized.
Interface signals are set.
Alarm display.
Remedy: Do not program spline and polynomial interpolation, or retrofit the necessary option.
Program Clear alarm with NC START or RESET key and continue the program.
Continuation:
Alarms
Diagnostics Manual, 07/2010, 6FC5398-8BP40-0BA0
NCK alarms
223