Stop active processing /STOPSIG/ No. 34
Definitions:
Stop the active processing.
(VDI signal, NC stop)
Should not occur in any alarm
Stop after block preparation /STOPATIPOBUFFER_ISEMPTY_ALARM/ No. 71
Definitions:
Stop at the end of block preparation (alarm)
Should not occur in any alarm
Stop all axes /STOPALL/ No. 29
Definitions:
Stop all axes
(VDI signal, stop all or by means of reset button)
Should not occur in any alarm
Stop all axes /STOP_ALARM/ No. 68
Definitions:
Stop all axes (alarm)
Should not occur in any alarm
Stop at end of asynchron. subroutine /STOPPROGATASUPEND/ No. 43
Definitions:
Stop at ASUB end if started from "stopped" (internal command)
Should not occur in any alarm
Stop at end of block /STOPATEND_ALARM/ No. 67
Definitions:
Stop at the block boundary (alarm)
Should not occur in any alarm
Stop digitizing processing /STOPDIGITIZE/ No. 32
Definitions:
! Digitize function removed !
Stop the digitizer processing.
(VDI signal, NC stop)
Should not occur in any alarm
Stop JOG motion /STOPJOGREF/ No. 31
Definitions:
Stop the JOG motion
Should not occur in any alarm
Alarms
Diagnostics Manual, 07/2010, 6FC5398-8BP40-0BA0
List of actions
927