Block %2: %Feed Insertion <=0; Block %2: Feed Dressing <=0; Block %2: Finished Part Diameter Too Small; Block %2: Tool Width Incorrectly Defined - Siemens Sinamics S120 Diagnostic Manual
Hide thumbs
Also See for Sinamics S120:
- Function manual (1094 pages) ,
- Manual (848 pages) ,
- Equipment manual (570 pages)
Table of Contents
Advertisement
61564
%[[Channel %1: ] Block %2: %]Feed insertion <=0
Parameters:
%1 = Channel number
%2 = Block number, label channel number
Definitions:
The alarm can be triggered by the following grinding cycles: CYCLE434, CYCLE444
Remedy:
Check values in grinding wheel data
Program
Clear alarm with the RESET key. Restart part program
Continuation:
61565
[Channel %1: ] Block %2: Feed dressing <=0
Parameters:
%1 = Channel number
%2 = Block number, label channel number
Definitions:
The alarm can be triggered by the following grinding cycles: CYCLE434, CYCLE444
Remedy:
Check values in grinding wheel data
Program
Clear alarm with the RESET key. Restart part program
Continuation:
61601
[Channel %1: ] Block %2: Finished part diameter too small
Parameters:
%1 = Channel number
%2 = Block number, label
Definitions:
The programmed radius of the machined part is too small. Alarm triggered by following cycles: CYCLE94, CYCLE96.
Remedy:
Check parameter SPD or DIATH.
Program
Clear alarm with the RESET key. Restart part program
Continuation:
61602
[Channel %1: ] Block %2: Tool width incorrectly defined
Parameters:
%1 = Channel number
%2 = Block number, label
Definitions:
Plunge cutter is larger than the programmed groove width. Alarm triggered by following cycle: CYCLE93.
Remedy:
Check tool or change program.
Program
Clear alarm with the RESET key. Restart part program
Continuation:
61603
[Channel %1: ] Block %2: Recess type incorrectly defined
Parameters:
%1 = Channel number
%2 = Block number, label
Definitions:
Radii/chamfers at the groove base do not match the groove width. Face groove on a contour element running parallel
to the longitudinal axis is not possible. Alarm triggered by following cycle: CYCLE93.
Remedy:
Check parameter VARI.
Program
Clear alarm with the RESET key. Restart part program
Continuation:
Alarms
Diagnostics Manual, 07/2010, 6FC5398-8BP40-0BA0
NCK alarms
463
Hide quick links:
Advertisement
Table of Contents
