Block %2 Spindle %3 No Speed Programmed; Block %2 Following Spindle %3 Impermissible Programming; Block %2 Invalid Index For Tool Fine Compensation - Siemens Sinamics S120 Diagnostic Manual

NCK alarms
Reaction: Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy: Correct setting data or modify part program.
Program Clear alarm with the RESET key. Restart part program
Continuation:
16111 [Channel %1: ] Block %2 spindle %3 No speed programmed
Parameters: %1 = Channel number
%2 = Block number, label
%3 = Spindle
Definitions: Programming of a speed is expected.
Reaction: Correction block is reorganized.
Interface signals are set.
Alarm display.
Remedy: Program speed with S[spindle number]=..
Program Clear alarm with NC START or RESET key and continue the program.
Continuation:
16112 [Channel %1: ] Block %2 following spindle %3 Impermissible programming
Parameters: %1 = Channel number
%2 = Block number, label
%3 = Spindle
Definitions: With synchronous spindle-VV-coupling an additional motion for the following spindle can only be programmed with
M3, M4, M5 and S... The paths created by specified positions cannot be maintained safely for a velocity coupling,
especially if a position control is missing. If dimensional accuracy or reproducibility are not important, the alarm can
be suppressed with MD11410 $MN_SUPPRESS_ALARM_MASK Bit27 = 1.
Reaction: Correction block is reorganized.
Interface signals are set.
Alarm display.
Remedy: Use synchronous spindle-DV-coupling or program direction of rotation and speed.
Program Clear alarm with NC START or RESET key and continue the program.
Continuation:
16120 [Channel %1: ] Block %2 invalid index for tool fine compensation
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: Mistake in programming: The 2nd parameter in the PUTFTOC command indicates for which tool parameter the value
is to be corrected (1 - 3 tool lengths, 4 tool radius). The programmed value is beyond the permitted range.
Permissible values are 1 - 4 if on-line tool radius compensation is allowed (see MD20254
$MC_ONLINE_CUTCOM_ENABLE), otherwise values 1 - 3.
Reaction: Correction block is reorganized.
Interface signals are set.
Alarm display.
Remedy: Modify part program: Length 1 - 3 or 4 permissible for radius.
Program Clear alarm with NC START or RESET key and continue the program.
Continuation:
222
Diagnostics Manual, 07/2010, 6FC5398-8BP40-0BA0
Alarms