Block %2: Unable To Determine Contour Direction; Block %2: No Material Available For Machining; Block %2: Cutting Edge Not Compatible With Cutting Direction; Block %2: Machined Part Contour Is Outside The Blank Contour - Siemens Sinamics S120 Diagnostic Manual
Hide thumbs
Also See for Sinamics S120:
- Function manual (1094 pages) ,
- Manual (848 pages) ,
- Equipment manual (570 pages)
Table of Contents
Advertisement
61731
%[[Channel %1: ] Block %2: %]Unable to determine contour direction
Parameters:
%1 = Channel number
%2 = Block number, label
Definitions:
Alarm triggered by following cycle: CYCLE952
Reaction:
Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy:
- Check contours
- Check whether the contour starting point exists
Program
Clear alarm with the RESET key. Restart part program
Continuation:
61732
%[[Channel %1: ] Block %2: %]No material available for machining
Parameters:
%1 = Channel number
%2 = Block number, label
Definitions:
Alarm triggered by following cycle: CYCLE952
Reaction:
Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy:
- Check programming of the blank and machined part contour, particularly their position towards each other
Program
Clear alarm with the RESET key. Restart part program
Continuation:
61733
%[[Channel %1: ] Block %2: %]Cutting edge not compatible with cutting direction
Parameters:
%1 = Channel number
%2 = Block number, label
Definitions:
Alarm triggered by following cycle: CYCLE952
Reaction:
Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy:
- Check cutting edge position and cutting direction in tool management
Program
Clear alarm with the RESET key. Restart part program
Continuation:
61734
%[[Channel %1: ] Block %2: %]Machined part contour is outside the blank contour
Parameters:
%1 = Channel number
%2 = Block number, label
Definitions:
Alarm triggered by following cycle: CYCLE952
Reaction:
Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy:
- Check programming of the machined part and blank contour, particularly their position towards each other
Program
Clear alarm with the RESET key. Restart part program
Continuation:
Alarms
Diagnostics Manual, 07/2010, 6FC5398-8BP40-0BA0
NCK alarms
471
Hide quick links:
Advertisement
Table of Contents
