Block %2: Starting Point Cannot Be Approached Without Collision; Block %2: Parking Position Is Below Return Plane Xra - Siemens Sinamics S120 Diagnostic Manual

NCK alarms
Remedy: Adjust the retraction planes.
Program Clear alarm with the RESET key. Restart part program
Continuation:
61283 [Channel %1: ] Block %2: direct approach not possible, as tool change required
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: After block search a position is to be reached by direct approach, but a tool change is required before.
Alarm triggered by following cycle: F_TFS.
Reaction: Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy: First execute a manual tool change, then restart the block search.
Program Clear alarm with the RESET key. Restart part program
Continuation:
61284 [Channel %1: ] Block %2: starting point cannot be approached without collision. Pre-
position tool manually
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: The starting point cannot be approached without collisions.
Alarm triggered by following cycles: F_DRILL, F_DRILLC, F_DRILLD, F_DRM_DR, F_DRM_PE, F_DRM_RE,
F_DRM_SI, F_DRM_TA, F_GROOV, F_MIM_TR, F_PARTOF, F_SP_EF, F_TAP, F_TR_CON, F_UCUT_T.
Reaction: Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy: Preposition the tool manually.
Program Clear alarm with the RESET key. Restart part program
Continuation:
61285 [Channel %1: ] Block %2: parking position is below return plane XRA.
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: The parking position is below retraction plane XRA.
Alarm triggered by following cycle: F_SP_RP.
Reaction: Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy: Move the parking position above retraction plane XRA.
Program Clear alarm with the RESET key. Restart part program
Continuation:
426
Diagnostics Manual, 07/2010, 6FC5398-8BP40-0BA0
Alarms