Block %2: Parameter For Measuring Axis Rotary Axis 1 Or 2 Incorrect; Sum Of The Active Offsets Does Not Equal Zero; Tool Data Of The Active Workpiece Probe Incorrect Or Inactive; Block %2: Error While Creating Log File - Error Code: %4 - Siemens Sinamics S120 Diagnostic Manual

NCK alarms
61425 [Channel %1: ] Block %2: Parameter for measuring axis rotary axis 1 or 2 incorrect ->
Error code: %4
Parameters: %1 = Channel number
%2 = Block number, label channel number
Definitions: The alarm can be triggered by the following measuring cycles: CYCLE996
Remedy: Causes of error:
1. Error code = A
2. Error code = B
3. Error code = C
4. Error code = D
5. Error code = E
61426 [Channel %1: ] Block %2: Sum of the active offsets does not equal zero -> Error code:
%4
Parameters: %1 = Channel number
%2 = Block number, label channel number
Definitions: The alarm can be triggered by the following measuring cycles: CYCLE996
Remedy: Causes of error:
Check the overview of active offsets ($P_ACTFRAME)
1. Error code = A
2. Error code = B
3. Error code = C
4. Error code = D
5. Error code = E
61427 [Channel %1: ] Block %2: Tool data of the active workpiece probe incorrect or inactive
--> Error code: %4
Parameters: %1 = Channel number
%2 = Block number, label channel number
Definitions: The alarm can be triggered by the following measuring cycles: CYCLE996
Remedy: Causes of error:
1. Error code = A
2. Error code = B
61428 [Channel %1: ] Block %2: Error while creating log file -> Error code: %4
Parameters: %1 = Channel number
%2 = Block number, label channel number
Definitions: The alarm can be triggered by the following measuring cycles: CYCLE996
Remedy: Causes of error:
1. Error code = A
2. Error code = B
450
-> Rotary axis number incorrect (1 or 2)
-> No name agreed for rotary axis 1
-> Rotary axis vector 1 equals zero
-> No name agreed for rotary axis 2
-> Rotary axis vector 2 equals zero
-> Sum of the translatory offsets of the geometry axes <> 0
-> Sum of the fine offsets of the geometry axes <> 0
-> Sum of the rotary components of the geometry axes <> 0
-> Sum of the translatory offsets of rotary axis 1 <> 0
-> Sum of the translatory offsets of rotary axis 2 <> 0
-> Workpiece probe (or tool edge) inactive
-> Length L1 of the workpiece probe = 0
-> Number of log files in the current directory > 99
-> Log files too long. Rename or delete log files,
check MD11420 $MN_LEN_PROTOCOL_FILE.
Diagnostics Manual, 07/2010, 6FC5398-8BP40-0BA0
Alarms