Block %2: Chamfer/Radius Too Large; Block %2: No Finishing Allowance Programmed; Block %2: Error While Traveling To Fixed Stop - Siemens Sinamics S120 Diagnostic Manual

Reaction: Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy: Decrease key width/edge length.
Program Clear alarm with the RESET key. Restart part program
Continuation:
61252 [Channel %1: ] Block %2: Chamfer/radius too large
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: Chamfer/radius is too large.
Alarm triggered by following cycle: CYCLE79.
Reaction: Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy: Decrease chamfer/radius.
Program Clear alarm with the RESET key. Restart part program
Continuation:
61253 [Channel %1: ] Block %2: No finishing allowance programmed
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: No finishing allowance has been entered.
Alarm triggered by following cycles: E_PO_CIR, E_PO_REC, E_SL_CIR, E_SL_LON, F_PO_CIR, F_PO_REC,
F_SL_CIR, F_SL_LON.
Reaction: Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy: Programm a finishing allowance.
Program Clear alarm with the RESET key. Restart part program
Continuation:
61254 [Channel %1: ] Block %2: Error while traveling to fixed stop
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: Error on travelling to fixed stop.
Alarm triggered by following cycle: F_SUB_SP.
Reaction: Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy: specify another Z1 position for gripping the counterspindle.
Program Clear alarm with the RESET key. Restart part program
Continuation:
Alarms
Diagnostics Manual, 07/2010, 6FC5398-8BP40-0BA0
NCK alarms
417