[Channel %1:] Invalid Configuration In Chained Transformation No. %2; [Channel %1:] Invalid Geoaxis Assignment In Machine Data %2[%3] - Siemens Sinamics S120 Diagnostic Manual

NCK alarms
Reaction: Correction block is reorganized.
Interface signals are set.
Alarm display.
NC Stop on alarm at block end.
Remedy: Specify the axis available in the channel.
Program Clear alarm with the RESET key. Restart part program
Continuation:
4345 [Channel %1: ] Invalid configuration in chained transformation no. %2
Parameters: %1 = Channel number
%2 = Transformation number
Definitions: A chained transformation is incorrectly configured (MD24995 $MC_TRACON_CHAIN_1 or MD24996
$MC_TRACON_CHAIN_2). The following causes for the error are possible:
- The list of transformations to be chained starts with a 0 (at least one entry not equal to zero is required).
- The list of transformations to be chained contains the number of a transformation which does not exist.
- The number of a transformation in the list is greater than or equal to the number of the chained transformation. Exam-
ple: The cascaded transformation is the fourth transformation in the system, i.e. MD24400 $MC_TRAFO_TYPE_4 =
8192. In this case, only values 1, 2 or 3 may be entered in the associated list (e.g. MD24995
$MC_TRACON_CHAIN_1[...]).
- The chaining setting is invalid. The following restrictions currently apply. A maximum of two transformations can be
chained. The first transformation must be an orientation transformation, transmit, peripheral curve transformation or
inclined axis. The second transformation must be the inclined axis transformation.
Reaction: Correction block is reorganized.
Interface signals are set.
Alarm display.
NC Stop on alarm at block end.
Remedy: Set a valid transformation chain.
Program Clear alarm with the RESET key. Restart part program
Continuation:
4346 [Channel %1: ] Invalid geoaxis assignment in machine data %2[%3]
Parameters: %1 = Channel number
%2 = Name of machine data
%3 = Transformation number
Definitions: MD2.... $MC_TRAFO_GEOAX_ASSIGN_TAB_... contains an invalid entry. The following causes for the error are pos-
sible:
- The entry references a channel axis which does not exist.
- The entry is zero (no axis) but the transformation needs the relevant axis as a geometry axis.
Reaction: Correction block is reorganized.
Interface signals are set.
Alarm display.
NC Stop on alarm at block end.
Remedy: Correct the entry in MD2.... $MC_TRAFO_GEOAX_ASSIGN_TAB_ or MD2.... $MC_TRAFO_AXES_IN_.
Program Clear alarm with the RESET key. Restart part program
Continuation:
42
Diagnostics Manual, 07/2010, 6FC5398-8BP40-0BA0
Alarms