Disable; Dns-Server - Dell C9000 Series Reference Manual

disable

Disable the DHCP server.
C9000 Series
Syntax
disable
DHCP Server is disabled by default. To enable the system to be a DHCP server, use the
no disable command.
Defaults Disabled
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms, refer
to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.9(0.0)
9.2(1.0)
8.3.19.0
8.3.11.1
8.3.7.0
8.2.1.0

dns-server

Assign a DNS server to clients based on address pool.
C9000 Series
Syntax
dns-server address [address2...address8]
Parameters
address
Defaults none
Command Modes DHCP <POOL>
Description
Introduced on the C9010.
Introduced on the Z9500.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the C-Series and S-Series.
Enter a list of DNS servers that may service clients on the subnet.
You may list up to eight servers, in order of preference.
Dynamic Host Configuration Protocol (DHCP) 807