Document Too Short Rap - Xerox WorkCentre 5687 Series Service Manual

05-310 Document too Short RAP

05-310 The DADH detects a document that is shorter than 110mm.
Initial Actions
• Remove all documents from the DADH.
• Make sure that the documents are longer than 110 mm (4.3 inches).
Procedure
If the documents are longer than 110mm, go to the procedures that follow:
• 05-330, 05-331 DADH Feed Sensor Failure RAP.
• 05-335 DADH Takeaway Sensor Failure RAP.
• 05-350, 05-352 DADH CVT Sensor Failure RAP.
• 05-340 DADH Registration Sensor Failure RAP.
Status Indicator RAPs
05-310, 05-330, 05-331
05-330, 05-331 DADH Feed Sensor Failure Entry RAP
05-330 The DADH feed sensor does not detect the lead edge of the document within the cor-
rect time after the feed motor runs.
05-331 The DADH feed sensor does not detect the trail edge of the document within the cor-
rect time.
Procedure
Switch off the electricity to the machine, GP 14. Disconnect the power cord from the
customer supply while performing tasks that do not need electricity. Electricity can
cause death or injury. Moving parts can cause injury.
Identify the speed of the machine, refer to SCP 7 Machine Features. Perform one of the steps
that follow:
• If the speed of the machine is 32-38 ppm, go to the 05-330A, 05-331A DADH Feed Sen-
sor Failure RAP (32-38 ppm).
• If the speed of the machine is 45-87 ppm, go to the 05-330B, 05-331B DADH Feed Sen-
sor Failure RAP (45-87 ppm).
August 2007
2-112
WARNING
WorkCentre 5687 Family