Creating A Dl Mimo Signal Using Pathwave Signal Generation - Keysight M9383B Measurement Manual

5G NR Measurements Using the VSA Software
5G Waveform and EVM Analysis Using VSA Software

Creating a DL MIMO Signal Using PathWave Signal Generation

This procedure will show you how to configure and analyze a downlink (DL)
multiple input, multiple output (MIMO) signal using PathWave Signal
Generation and the VSA software. The hardware setup below includes a
2-channel VXG signal generator and a 2+ channel, 33 GHz or higher Infiniium
UXR-Series Oscilloscope.
If you do not have access to a Keysight Infiniium UXR Real-Time Oscilloscope,
TIP
a UXR recording waveform file has been included in the Example waveform
file folder:
D:\Users\Instrument\Documents\Keysight\PathWave
\SignalGenerator\Examples
You will need to copy the 5GNR_UXR_Recording_28GHz.csv file to the
N9040B or the PC running the VSA application.
From the VSA menu panel, select File > Recall Recording and navigate to the
waveform file. Refer to the Keysight 89600 VSA Software Help for more
information.
Equipment Setup for the M9383B
— CH1 M9323A front panel RF Out to UXR front panel CH1
— CH2 M9323A front panel RF Out to UXR front panel CH3
— CH1 M9343A front panel Trig 1 to UXR rear panel Aux Trig In
138 M9383B/84B Measurement Guide