Table of Contents
Advertisement
4 - Front Panel Operation
10 - Setting the GPIB Address and RS-232 Parameters
Your ac source is shipped with the GPIB address set to 5 This address can only be changed from the front
panel using the Address menu located under the
GPIB or RS-232 interface, and specify RS-232 parameters such baud rate and parity.
Action
To set the GPIB address, proceed as follows:
1.
On the System keypad, press Address.
2.
Enter the new address. For example, Press 7, Enter.
To configure the RS-232 interface, proceed as follows:
1.
On the System keypad, press Address.
Scroll through the Address menu by pressing . The interface command
2.
lets you select either the GPIB or the RS-232 interface. The baudrate
command selects the baudrate. The parity command selects the parity.
The and keys let you select the command parameters.
3.
11 - Saving and Recalling Operating States
You can save up to 16 states (from location 0 to location 15) in non-volatile memory and recall them
from the front panel. All programmable settings are saved. List data, however, cannot be saved in state
storage. Only one list is saved in non-volatile memory.
Action
To save an operating state in location 1, proceed as follows:
1.
Set the instrument to the operating state that you want to save.
Save this state to location 1. Press Shift Save 1 Enter.
2.
To recall a saved state in location 1, proceed as follows:
1.
Recall the state saved in location 1 by pressing Recall 1 Enter
To select the power-on state of the ac source, proceed as follows:
1.
On the Function keypad, press Shift Output, and scroll through the Output
menu until you get to the PON state command.
Use the and keys to select either RST or RCL0. RST sets the power-on
2.
state of the unit as defined by the *RST command. RCL0 sets the power-on
state of the unit to the state saved in *RCL location 0.
To clear the non-volatile memory of the ac source, proceed as follows:
1.
On the Function keypad, press Shift Output and scroll to the *RST com-
mand. Then press Enter. This returns the unit to the factory-default settings.
2.
Save these settings to location 1. Press Shift Save 1 Enter.
3.
Repeat step #2 for memory locations 2 through 16..
58
Address
key. This menu is also used to select either the
Display
ADDRESS 5
ADDRESS 7
ADDRESS 5
INTF RS232
BAUDRATE 600
PARITY EVEN
Display
*SAV 1
*RCL 1
PON:STATE RST
*RST
*SAV 1
*SAV 2
*SAV 3
*SAV 4
.
.
...*SAV 16
Advertisement
Table of Contents
