Table of Contents
Advertisement
Setting Up Measurement Conditions and Display
Saving/Recalling Instrument Setup State (Save/Recall Function)
Saving/Recalling Instrument Setup State (Save/Recall Function)
You can save/recall up to 20 instrument settings into/from the built-in
nonvolatile memory (Flash memory, 0 through 9) and external USB memory
(10 through 19).
The ninth instrument setting corresponds to Auto Recall.
Auto recall is not executed when power is ON, by pressing the [Preset] key.
For information on the instrument setups you can save/recall, refer to
Operation Manual, Appendix C "Initial Setting".
Saving instrument setup state
To save the instrument setup state, use the following command.
•
•
Recalling saved instrument setup state
To recall the saved instrument setup state, use the following command.
•
•
Keysight E4981A 120 Hz/1 kHz/1 MHz Capacitance Meter
on page 161
*SAV
:MMEMory:STORe:STATe[:REGister]
on page 160
*RCL
:MMEMory:LOAD:STATe[:REGister]
on page 229
on page 229
47
Advertisement
Table of Contents
