To 299, Signal Integrity - Keysight X-Series Manual

Instrument Messages
Condition Messages
Err# Bit in Message
status
register
159 13
Settings Alert;Sweep Rate
Unavailable
159 13
Settings Alert;Span:RBW Ratio too
big
159 13
Settings Alert;Freq>USB Preamp
max
161 14
Setting Modified
161 14
Setting Modified; Filter not
applied
a. The Input Overload error is not reported to the SCPI queue unless the :SYSTem:ERRor:OVERload ON
command has been issued, however it always sets the status bit.

201 to 299, Signal Integrity

This series of errors corresponds to the bits in the
STATus:QUEStionable:INTegrity:SIGNal
Register System" on page
corresponding bit in that register.
An event with the number shown in the table means the condition has been
detected. When the condition is cleared, an event with the number plus 1000
is generated. These error numbers can be viewed in the Show Errors screen,
along with the DETECTED and CLEARED indicators.
For example, error 207 indicates a Burst Not Found condition has been
detected, error 1207 indicates that failure has been cleared.
Instrument Messages
Error or More Information
Warning
W The auto coupled sweep time exceeds
the maximum allowed. Therefore, full
amplitude accuracy cannot be
attained. Please increase the RBW or
reduce the span.
W The chosen large ratio of span to RBW
is not possible. Please reduce the
span or increase the RBW and/or FFT
Width.
W The highest analysis frequency
exceeds the frequency range of the
USB preamp used. In Noise Figure
measurement applications, this
situation will cause gradual
degradation of uncertainty with
increasing frequency. In Spectrum
Analyzer applications, this will cause
rapidly declining amplitude accuracy
with increasing frequency.
E
E The filter you have selected is larger
than the sampling frequency. You
should select a different filter.
sub-register (see
116). The second column in the table shows the
"X-Series Status
97