Vrrp Global Settings; Vrrp Virtual Router Settings - D-Link xStack DGS-3620 Series Reference Manual

®
xStack DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch Web UI Reference Guide
To configure VRRP for virtual routers on the Switch, an IP interface must be present on the system and it must be a
part of a VLAN. VRRP IP interfaces may be assigned to every VLAN, and therefore IP interface, on the Switch.
VRRP routers within the same VRRP group must be consistent in configuration settings for this protocol to function
optimally.

VRRP Global Settings

This window is used to configure the VRRP Global settings for this switch.
To view the following window, click L3 Features > VRRP > VRRP Global Settings, as shown below:
The fields that can be configured are described below:
Parameter
VRRP State
Non-owner Response
Ping
Click the Apply button to accept the changes made.

VRRP Virtual Router Settings

This window is used to configure the VRRP virtual router settings.
To view the following window, click L3 Features > VRRP > VRRP Virtual Router Settings, as shown below:
The fields that can be configured are described below:
Parameter
Interface Name
Figure 6-137 VRRP Global Settings window
Description
Click the radio buttons to enable or disable the VRRP Global state.
Click the radio buttons to enable or disable that the virtual IP address is allowed to be
pinged from other host end nodes to verify connectivity.
Figure 6-138 VRRP Virtual Router Settings window
Description
Specifies the IP interface name used to create a VRRP entry.
297