Traffic Segmentation Commands; Config Traffic_Segmentation; Show Traffic_Segmentation - D-Link DGS-1100-06/ME Cli Reference Manual

The Traffic Segmentation commands in the Command Line Interface (CLI) are listed (along with the
appropriate parameters) in the following table.
Command
config
traffic_segmentation
show traffic_
segmentation
Each command is listed in detail, as follows:

config traffic_segmentation

Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To configure ports 1~3 to be able to forward frames to port 5:
DGS-1100-06/ME:5#config traffic_segmentation 1-3 forward_list 5
Command: config traffic_segmentation 1-3 forward_list 5
Success.
DGS-1100-06/ME:5#

show traffic_segmentation

Purpose
Syntax
Description
Parameters
DGS-1100-06/ME Metro Ethernet Managed Switch CLI Reference Guide

TRAFFIC SEGMENTATION COMMANDS

Parameter
<portlist> forward_list [null | <portlist>]
{<portlist>}
To configure traffic segmentation on the Switch.
config traffic_segmentation <portlist> forward_list [null |
<portlist>]
The config traffic_segmentation command configures traffic
segmentation on the Switch.
<portlist> – A port or a port channel for which the current traffic
segmentation configuration on the Switch is to be displayed.
forward_list – Specifies a port or a port channel to receive forwarded
frames from the source ports specified in the portlist, above.
Only administrator or operator-level users can issue this command.
To display the current traffic segmentation configuration on the
Switch.
show traffic_segmentation {<portlist>}
The show traffic_segmentation command displays the current
traffic segmentation configuration on the Switch.
<portlist> – A port or a port channel for which the current traffic
segmentation configuration on the Switch is to be displayed.
246
37