Show Serial; Telnet Commands; Ip Telnet Server Enable - D-Link DWL-8500AP Command Reference Manual

CLI Command Reference
no serial timeout
This command sets the maximum connect time (in minutes) without console activity.
Format
Mode

show serial

This command displays serial communication settings for the switch.
Format
Modes
Serial Port Login Timeout (minutes) The time, in minutes, of inactivity on a Serial port
Baud Rate (bps) The default baud rate at which the serial port will try to connect. The avail-
Character Size (bits) The number of bits in a character. The number of bits is always 8.
Flow Control Whether Hardware Flow-Control is enabled or disabled. Hardware Flow Con-
Stop Bits
Parity Type

Telnet Commands

This section describes the commands you use to configure and view Telnet settings. You can
use Telnet to manage the device from a remote management host.

ip telnet server enable

Use this command to enable Telnet connections to the system and to enable the Telnet Server
Admin Mode. This command opens the Telnet listening port.
Default
Format
Mode
no ip telnet server enable
Use this command to disable Telnet access to the system and to disable the Telnet Server
Admin Mode. This command closes the Telnet listening port and disconnects all open Telnet
sessions.
298 © 2001- 2008 D-Link Corporation/D-Link Systems, Inc. All Rights Reserved.
no serial timeout
Line Config
show serial
Privileged EXEC
User EXEC
connection, after which the Switch will close the connection. Any numeric
value between 0 and 160 is allowed, the factory default is 5. A value of 0 dis-
ables the timeout.
able values are 1200, 2400, 4800, 9600, 19200, 38400,57600, and 115200
baud. The factory default is 9600 baud.
trol is always disabled.
The number of Stop bits per character. The number of Stop bits is always 1.
The Parity Method used on the Serial Port. The Parity Method is always
None.
enabled
ip telnet server enable
Privileged EXEC