DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide
40. Filter Database (FDB) Commands
40-1 clear mac-address-table
This command is used to delete a specific dynamic MAC address, all dynamic MAC addresses on a
particular interface, all dynamic MAC addresses on a particular VLAN, or all dynamic MAC addresses
from the MAC address table.
clear mac-address-table dynamic {all | address MAC-ADDR | interface INTERFACE-ID | vlan
VLAN-ID}
Parameters
all
address MAC-ADDR
interface INTERFACE-ID
vlan VLAN-ID
Default
None.
Command Mode
Privileged EXEC Mode.
Command Default Level
Level: 12.
Usage Guideline
Using this command only clears dynamic MAC address entries. Only the dynamic unicast address entry
will be cleared.
Example
This example shows how to remove the MAC address 00:08:00:70:00:07 from the dynamic MAC address
table.
Switch# clear mac-address-table dynamic address 00:08:00:70:00:07
Switch#
40-2 mac-address-table aging-time
This command is used to configure the MAC address table ageing time. Use the no form of the command
to revert to the default setting.
mac-address-table aging-time SECONDS
no mac-address-table aging-time
Parameters
Specifies to clear all dynamic MAC addresses.
Specifies to delete the specified dynamic MAC address.
Specifies the interface that the MAC address will be deleted from. The
specified interface can be a physical port or a port-channel.
Specifies the VLAN ID. The valid values are from 1 to 4094.
502