Inter-Tel AXXESS Manual page 440

Voice Processing Features
® ®
INTER-TEL AXXESS
•
•
Software Configuration
2.30 The following list describes the programming requirements necessary for AMIS net-
working.
•
•
•
•
•
•
Page 4-14
MANUAL VERSION 11.0 – May 2008
Full duplex message flow is not supported. After the originating system has transferred
its messages to the destination system, if the destination system has pending messages
for the originating system, it cannot transmit them during the same call. The destination
system must make a separate call to transfer its pending messages. In other words, only
the system that originates the call can transfer messages during that call.
The retransmission of data frames in the event of an interdigit time out is not supported.
System\Premium Features: The Voice Processor AMIS Networking software license
is required.
System\Devices and Feature Codes\Stations: There must be at least one off-node
device for a station on the remote node programmed for AMIS networking. This off-
node device is required before creating the network mailbox below.
Voice Processor\Devices\Applications:
— There must be a Message Notification/Retrieval Application programmed with
outgoing access.
— There must be a Call Routing Announcement application that has the Accept
AMIS Calls flag enabled. The Call Routing Application's greeting must consist of
only a 15-second pause, because AMIS disconnects if it detects voice.
Voice Processor\Devices\Nodes: The node table must contain an entry that is pro-
grammed for AMIS networking.
Voice Processor\Devices\Mailboxes: There must be at least one network mailbox on
the local Voice Processing Unit that refers to a network node programmed for AMIS
networking. For example, if entry 5 in the Network Node Table is programmed for
AMIS networking, then at least one network mailbox must have node 5 in its Network
Node Number field.
Voice Processor\Networking\AMIS:
— The IC or CO System Number field must be programmed to allow the Voice Pro-
cessing Unit to identify itself when establishing an AMIS session and to allow the
remote AMIS system to be able to return calls to the local Voice Processing Unit.
— The Accept Unknown Network Calls flag must be enabled (or there must be a pro-
grammed node for each remote node from which the local Voice Processing Unit
expects to receive AMIS calls). If the Accept Unknown Network Calls flag is
enabled, the local Voice Processing Unit can accept calls from any Voice Mail sys-
tem that supports AMIS networking. If this flag is disabled, the local Voice Pro-
cessing Unit can only accept network calls from nodes that are programmed in the
network node table.
Software Configuration